Car and motorcycle tire service in Budaörs! The combined balance of the tire and wheel can only be achieved effectively with machines of the right quality, carefully and professionally adjusted. Regardless of the method used for dynamic or static wheel balancing, the result will be perfect in both cases under the right conditions.


“The claim is yours, the task is ours and will improve your carefree used vehicle!”


Even in the case of cars and motorcycles, the connection between the road / road and the vehicle is kept by the tire alone! The 2 or 4 baby palms / palm surfaces (quality and integrity) that come in contact with the road can be the deciding factor between total control or uncontrollability !!! Thus, an essential condition is:

  • in perfect condition (no abnormal deformation, traces of external damage or breakage of fibers on the sidewall or tread)
  • appropriate age and freshness (the age of the tire from the date of manufacture, which is: maximum 5 years for cars and maximum 2 years for motorcycles / scooters !!!)
  • with a suitable tread depth (covering the entire width of the tire !!!) according to the hungarian traffic regulations, a tread depth of 1.6 mm must be achieved as a minimum, in order to participate in the traffic for each tire !!!
  • setting and periodically checking the correct tire pressure (the tire pressure specified by the manufacturer in the owner’s manual or on the information plate on the car body / fuel tank / glovebox is ideal! – usually cold pressure is indicated by the manufacturers)
  • use of a tire of the right / optimal size and sidewall structure !!! A properly sized rim-mounted tire recommended by the factory, together with the chassis components, can provide the calculated adhesion to the vehicle!

It is FORBIDDEN to deviate from the size recommended by the manufacturer, for legal and safety reasons !!! (Depending on the make, model, model year and equipment of the vehicle, the rim is issued on the homologation data sheet issued / approved by the manufacturer and tire sizes may only be used! Otherwise individual modification approval is required!)


Minimum profile depths recommended by:
MannMotors Tire Service – Budaörs

For passenger cars / vans, winter tires (recommended minimum tread depth: 5.5 mm) are removed from the production line with a deeper tread (8 – 10 mm), while summer tires (recommended minimum tread depth: 4.5 mm) are removed from the production line. produced with a relatively smaller depth (7.5 to 9 mm).

For motorcycles (Street, Enduro and Cross patterns) and scooters, the rear tire (4 – 12 mm) is always made with a deeper pattern / profile than the front tire (3 – 8 mm). The “sample number” or depth of motorcycle tires also depends on the intended use of the tire! In the case of SuperSport tires, the tire is retreaded, which is also part of the street homologation condition system, and the pattern / ditch has the ability to displace / drain water. The recommended minimum tire profile depths for motorcycles differ from the type of use of the tire and on the front and rear axles! (minimum: 3 mm)

Tasks of the tire service:
Tire service in Budaörs – Norbert Mann

+36-20-5465644

  • condition survey (condition and age)
  • tire and rubber valve replacement, balancing and wheel mounting on a vehicle
  • maintenance of metal and rubber parts, corrosion / oxide layer removal
  • puncture repair (ONLY if it can be repaired properly and safely !!!)
    / In the case of motorcycles and scooters, we will NOT repair a puncture !!! /
  • (mainly by visual inspection) detection of abnormal brake, chassis, suspension / shock absorber and steering faults


Key features of the tires:

For passenger car tires:

f.e.: 205/55R16 94W — DOT 2520

205/55R16 94W ==>

  • 205 = tread width in ‘mm’
  • 55 = the height of the sidewall, expressed as a percentage of the width of the tread
  • R16 = (‘R’ = Radial, indicates the structural construction of the tire) inner diameter of the tire (or outer diameter of the rim) expressed in 16 inches (= 406.4 mm) ==> (1 inch = 1 ″ = 25.4 mm),
  • 94 = index number indicating the maximum load capacity of the given tire (While maintaining the correct tire pressure !!!) – (‘94’ = 670 kg)
  • W= (SI = Speed ​​Index) maximum speed without damage, ( ‘W’ = 270 km / h )

For motorcycle and scooter tires:

f.e.: 180/55R17 Rear 73W TL — DOT 2520

180/55R17 Rear 73W TL ==>

  • 180 = tread width in ‘mm
  • 55 = the height of the sidewall, expressed as a percentage of the width of the tread
  • R17 = (‘R’ = Radial, indicates the structural construction of the tire) inner diameter of the tire (or outer diameter of the rim) expressed in 17 inches (= 431.8 mm) ==> (1 inch = 1 ″ = 25.4 mm)
  • 73 = index number (LI = Load Index = Load index), which indicates the maximum weight load of the given tire (While maintaining the correct tire pressure !!!) – (‘73’ = 365 kg)
  • W = (SI = Speed ​​Index) maximum speed without damage, permanently tolerable (‘W’ = 270 km / h)
  • TL = TubeLess (Note: TT = Tube Type)

DOT 2520 ==>

  • DOT = “The U.S. Department of Transportation (DOT)” indicates the date of manufacture (Only on one side of the tire!)
  • 2520 = the marked tire was manufactured in the 25th week of 2020


SI (Speed ​​Index = Tire Speed ​​Index) [km / h]
MannMotors tire service – in Budaörs:

SIkm/hSIkm/hSIkm/hSIkm/h
J100N140S180W270
K110P150T190Y300
L120Q160H210ZR240+
M130R170V240
www.mannmotors.hu – MannMotors – SI [km/h]


Car & Motorcycle
Tire Service Budaörs
Norbert Mann
+36-20-5465644


TPMS (Tire Pressure Monitoring System)

Run Flat Tire (ROF, RFT, RSC, SSR) only for use with TPMS!
The tire pressure monitoring system can be a first passive or an second active system.

1. Passive / indirect system:

Which can detect and indicate the defect with the signal extracted from the signal of the ABS (Anti-lock Braking System) disc or after the change of the tire diameter. Due to the decrease in tire pressure, the radius / diameter of the tire will also be smaller. As for the rolling length of the wheel (s), including the speed of the punctured wheel, the system will also show a difference.

2. active / direct system:

In the case of an active / direct system, the wheel is equipped with a sensor valve. In many cases, these encoder valves also measure temperature.
// This can be a rubber valve or a metal valve. //
Both constructions have advantages and disadvantages.

Advantages:
1. In case of passive / indirect system:
if in case of winter-summer tire change, it is not necessary to buy encoder valves for the winter rim
no special care
does not age (as opposed to encoder rubber valves)
lower unsprung mass (not significant in road use)
// In the event of a tire change, the possibility of damage to the encoder valve (in this case) is excluded. //
2. In case of active / direct system:
more accurate measurement
possibility of data recording (tire pressure and tire temperature)

Disadvantages:
1.In case of passive / indirect system:
more inaccurate measurement (usually indicated in case of pressure loss above 20%)
operates between 20-250 km/h
2.In case of active / direct system:
high-voltage wires hanging low over the road in places can interfere with “communication” between the transmitter and the receiver
in many cases requires special training / programming
higher unsprung weight (not significant in road use)
After 2-5 years, the valve electronics / encoder / battery will wear out ==> the valve(s) need to be replaced


Car rescue and delivery to the tire service:

If the car is impassable and needs to be delivered, I recommend AutómentésBudapest, a car recovery and transportation company. AutómentésBudapest carries out the transport to a high standard and with careful attention to the vehicle, so I recommend it with a good heart. Accident or inoperable HONDA car after many years of storage? Service – HONDA car service in Budaörs – Norbert Mann – delivery is no longer a problem! Rescue and delivery of cars contact: +36-20-3877709

Delivery and undertaking to the MannMotors workshop is ONLY possible after prior consultation !!!

Motorcycle rescue and delivery to the tire service:

If the bike is impassable and needs to be delivered, I recommend MotorAngel, a motorcycle recovery and transportation company. MotorAngel carries out the transport to a high standard and with careful attention to the vehicle, so I recommend it with a good heart. Accident or inoperable MOTORCYCLE after many years of storage? Service – Motorcycle service – Norbert Mann – delivery is no longer a problem!
Rescue & delivery of motorcycle contact: +36-30-7431277 or +36-20-6628838

Delivery and undertaking to the MannMotors workshop is ONLY possible after prior consultation !!!


If you have any questions about tires and wheels / rims, you can contact us at the contact details on this page: MannMotors contact

Car & Motorcycle
Tire Service Budaörs
Norbert Mann

+36-20-5465644